+86-19352709151
Hydraulic Puller Series
0102030405
TMMR Bidirectional curved puller
Function
1. When using, first insert the slotted end of the handle into the return oil valve stem, and tighten the return oil valve stem in a clockwise direction.
2. Adjust the hook and claw holder to grip the object being pulled.
3. Insert the handle into the lifting hand hole and lift the piston back and forth to smoothly move the starting rod forward. The claw hook should correspondingly move backward to pull out the object being pulled.
4. The effective distance of the piston starting rod of the hydraulic puller is only 50mm, so the extension during use should not exceed 50mm. When it is not pulled out, stop and release the oil return valve to retract the piston starting rod. After adjustment, repeat steps 1, 2, and 3 again until it is pulled out.
5. To retract the piston starting rod, simply use the slotted end of the handle to slightly loosen the return oil valve stem in a counterclockwise direction, and the piston starting rod will gradually retract under the action of the spring.
6. Before use, hydraulic pullers of the corresponding tonnage should be selected based on the outer diameter, pulling distance, and load force of the object being pulled. Overloading should be avoided to avoid damage.
7. This hydraulic puller is used at -5 ℃~45 ℃ and uses (GB443-84) N15 mechanical oil; Used at -20 ℃~-5 ℃, using (GB442-64) synthetic spindle oil.
8. To prevent equipment damage caused by overloading, the hydraulic device is equipped with an overload automatic unloading valve. When the pulled object exceeds the rated load, the overload valve will automatically unload, and a larger tonnage hydraulic puller will be selected instead.
Model
| TMMR 40e | TMMR 120e | TMMR 250e |
| TMMR 60e | TMMR 160e | TMMR 350e |
| TMMR 80e | TMMR 200e | TMMR 8e |